Home Search

DriveWorks Pro 22
Revolved Boss/Base Thin

Send Feedback

Revolved Boss/Base Thin

This document describes the types of rules that can be applied to models that have advanced feature parameters captured.

Driving advanced feature dimensions increases model generation time. Where possible capture feature dimensions (distances, numbers and angles) as dimensions rather than an advanced feature parameter.

During model generation captured dimensions are driven before captured advanced feature parameters. If the advanced feature parameter has also been captured as a dimension the value being driven into the advanced feature parameter will override the captured dimension.

Revolved Boss/Base Thin

ParameterTypeDescription
D1AngleAngleSet the revolution angle in direction 1
D2AngleAngleSet the revolution angle in direction 2
MergeTrue/FalseSet the revolution to merge with any intersecting bodies, or remain a separate body.
ReverseDirectionTrue/FalseSet the direction around the axis in which direction 1 extends
Primary Wall ThicknessDistanceSet the thickness of the thin feature in the primary direction
Secondary Wall ThicknessDistanceSet the secondary wall thickness in a TwoDirection Thin Wall Type thin feature
Type

One of the following values:

OneDirection

Midplane

TwoDirection

360Degrees

Creates a single direction revolve

Creates a revolve in both directions, extending half of D1Angle in each direction

Creates a revolve in both directions, defined by D1Angle and D2Angle

Creates a 360 degree revolve

ThinWallType

One of the following values:

OneDirection

OppDirection

Midplane

TwoDirection

Set the wall to be of Primary Wall Thickness from the sketch line

Set the wall to be of Primary Wall Thickness from the sketch line in the opposite direction

Set the wall to be of Primary Wall Thickness with the sketch line at the mid point of the thickness

Set the wall to be of Primary Wall Thickness from the sketch line in direction 1 and of Secondary Wall Thickness in direction 2