This Task will set a static value for a Check Value Condition that is applied to a Transition on a Target State.
See Condition Editor for more information about Conditions in Specification Flow and how to set them up.
See Check Value for more information about the Condition.
| Property Name | Description |
|---|---|
| Title | Changes the Title (not the name) of the Task. |
| Condition Value | TRUE to Allow the Operation, FALSE to not. |
| Transition Name | The Transition Name that you want to change on the State. |
| State Name | The Name of the State where this Transition is located. |
| Constant Name | Constant used to report on the success of the Specification Task (This is for reference only). |
When this Task is added the properties are static. To be able to build rules on a static property see How To: Change A Static Property To A Dynamic Property.
| Property Name | Example Rule | Example Result | Meaning |
|---|---|---|---|
| Condition Value | TRUE | TRUE | TRUE will allow the Operation to run. FALSE Will not. |
| Transition Name | "Complete" | Complete | This is the name of the Transition where the Check Value Condition is applied that you want to set the value for. |
| State Name | "Approved" | Approved | This is the name of the State that contains the Transition you wish to control with the Check Value Condition. |
| Constant Name | "DWConstantReport" | DWConstantReport | This is the name of the Constant that will be reported to with the success or failure of the Task. |
This task supports Status Outputs. These can be used to perform different actions depending on what the status outcome of the task is. For more information see Status Outputs in the Task Node Outputs section of Specification Macros Task Node.
The status output navigation is as follows:
Success
Success with Warnings
Failed (one of the following occurred)