DriveWorks Pro 15: Wrap [send feedback...]

Introduction

This document describes the types of rules that can be applied to models that have advanced feature parameters captured.

Driving advanced feature dimensions increases model generation time. Where possible capture feature dimensions (distances, numbers and angles) as dimensions rather than an advanced feature parameter.

During model generation captured dimensions are driven before captured advanced feature parameters. If the advanced feature parameter has also been captured as a dimension the value being driven into the advanced feature parameter will override the captured dimension.

Wrap

ParameterTypeDescription
ReverseDirectionTrue/FalseChoose to reverse the direction of the wrap feature
Type

One of the following values:

Emboss

Deboss

Scribe

Set Type as Emboss to create an extruded boss from the wrapped sketch.

Set Type as Deboss to create an extruded cut from the wrapped sketch.

Set Type as Scribe to create an imprint from the wrapped sketch.

Table of Contents